SMALL ROTARY SCREW RANGE

GX series: 2.2-11 kW / 3-15 hp 50/60 Hz

The GX2-11 series incorporates proven Atlas Copco industrial rotary screw technology, providing optimum performance, high reliability, long lifetime and reduced maintenance requirements.

Total integration of refrigerant dryer, compressed air filters and air tank results in a complete compressed air system, including all connections and outlet valve, in less then 1mē (<11kW). Combined with low noise levels, down to 61 dB(A), this makes the GX the perfect compressed air solution for workshops and light industry.

Compact and complete

1. Low pressure drops
2. Less chance for leakages no installation costs
3. A complete compressed air system in less than 1mē

Built-in reliability

• Industrial compressor technology
• High quality in design, components and manufacturing
• Complete compressed air system, factory tested

The use of Atlas Copco rotary elements, designed for 100% continuous operation and manufactured according to Atlas Copco's high quality standards, make the GX2-11 a highly reliable compressed air system.

Energy efficiency

More air for less power

• Energy saving control
• High efficiency rotary compressor element and electric motor
• Compact design

To save energy, the compressor automatically shuts down when no compressed air is needed.

Combined with the Atlas Copco screw element and a high efficiency motor, the GX offers low energy consumption and high air delivery during the entire compressor lifetime.

Quiet operation

• Rotary technology
• Specially designed low noise cooling fan
• Sound enclosure

With sound levels between 61 dB(A) and 69 dB(A), the GX can be installed anywhere in the workshop.

Clean and dry air

Save on operational costs by protecting downstream equipment and end products and protect the environment.

Moisture, dirt and aerosols in compressed air can damage tools and contaminate end products. All equipment required to clean and dry the air can be integrated within the GX:

• Three stage oil separation system with a residual oil carry over of less than 3 mg/m3.
• After cooler separating 70% of the water in the compressed air.
• A high performance refrigerant dryer to dry the compressed air.
• General purpose or high efficiency filter kit to further clean the compressed air.